Name: CLIP/CRUISE Wind sensor
Brand: Nasa

☀️ Garmin spring offer ☀️ Up to -38% off a selection ⏰ ends 04/30/24

⚡️ Get up to €500 back on your SIMRAD or B&G equipment ⏰ From 01/04/2024 to 31/05/2024.

-€19.10

Complete wireless or wired aerials are compatible with Clipper/Cruiser V1 and V2 displays. They allow you to measure wind speed and direction, and are easy to install.

NASA - REPLACEMENT SENSOR - REPLACE YOUR SENSOR

You can choose from several types of aerial: wireless or with 20-meter cable. They are compatible with Clipper and Cruiser V1 or V2 displays.


	WIRELESS WIND VANE This NASA wind vane with NMEA0183 output operates wirelessly. The pack includes the receiver. It must be installed indoors and supplied with a 12V power supply. This receiver displays wind speed and direction on every NMEA0183-compatible display. Specifications : NMEA0183, 4800 baud, MWV data Power supply (receiver): 6-16 V DC, approx. 17 mA Battery life (transmitter): up to 200 hours Battery recharge time (transmitter)

CLIPPER/CRUISER V1 AIRBORNE SENSOR Complete airborne sensor for NASA MARINE's first-generation Clipper, Target and Cruiser instruments. Supplied with 20m cable. Equipped with a 5-pin connector. Note : It is NOT compatible with the following sensors: CLIPPER WIND V2.0 - 3-pin connection TARGET WIND V2.0 - 3-pin connection CRUISER WIND V2.0 - 3-pin connection

	CLIPPER/CRUISER V2 OVERHEAD SENSOR Complete airborne sensor for NASA MARINE's second-generation Clipper and Cruiser instruments. Scope of delivery: 20 m cable with connector. Equipped with 4-pin connector. Note: It is NOT compatible with the following instruments: CLIPPER WIND V1.0 - 5-pin connector TARGET WIND V1.0 - 5-pin connector CRUISER WIND V1.0 - 5-pin connector