- -€16.74
Striker Plus 4 is a 4.3" GPS echo sounder with new Chirp technology. The integrated GPS is used to mark waypoints, create routes and display boat speed. The QuickDraw function lets you draw your own fishing charts.
Read more FeaturesData sheet
- Screen size
- 4"
- Sounder technology
- 2D
- Our opinion
- ★★★★★
- Range
- Striker
- Sounder power
- 200w
- Fishing area
- Small bottom
- GPS positioner function
- Yes
- Product type
- GPS sounder
GARMIN - STRIKER PLUS 4 - The 4.3" GPS fishfinder
Built for use in the most extreme environments, it features an anti-reflective coating and an ultra-bright 4.3" full sun display.
With its easy-to-use interface, Striker Plus 4 simplifies navigation, whatever the situation when you're in the water.
|
|
tRADITIONAL 2D CHIRPThe Striker Plus 4 provides ideal detection (down to 100m) without difficulty, thanks to its high-frequency CHIRP coverage on a wider beam than usual. CHIRP technology provides :
|
QUICKDRAW CONTOURS FUNCTIONQuickdraw Contours software creates HD fishing charts in real time. It's now possible to create your own maps without any special knowledge. With Striker Plus 4, you can store the equivalent of 8,000 km² of Quickdraw Contours maps, with bathymetric curves displayed every 30 cm. |
![]() |
![]() |
GPS ECHO SOUNDERWherever you are, the high-sensitivity GPS antenna integrates your GPS positions. It lets you quickly find your fishing spots with ease. |
KEY FEATURES :
|
BOX CONTENTS :
|
Accessories
Customer Reviews (3)
Questions / Answers (1)
Hi, I recently bought a Striker Vivid and I'm having a few problems connecting it to the battery correctly. The power cable supplied with the device has 4 wires of different colors: brown, blue, black and red. I'd like to know which wires I should connect to the battery's positive and negative terminals. What should-I do with the remaining 2 wires?
On the other hand, I noticed a yellow terminal on the back of the unit's screen. Could-you tell me what it does?
Hello, to connect the Striker Vivid device to the battery, you need to connect :
- The red wire to the positive (+) battery terminal
- The black wire to the negative terminal (-) of the battery
The other two wires, brown and blue, are not required for basic power supply. You can insulate them with a piece of tape to prevent them from shorting-circuiter.
These brown and blue wires are actually used for data communication between your device and another model in the same range, should you wish to use this advanced feature.
Concerning the yellow lug on the back of the device, this is the "ground lug", and must be connected to ground.
Please refer to the installation manual for wiring instructions on page 2: https://static.garmin.com/pumac/STRIKER_Vivid_5_7_9_install.pdf


