Extasy Glue for PVC

SURFACE AND CONTOUR

• Before you start gluing your Plug&Go patch or holder, make sure that the two surfaces to be glued (pad and float tube) are clean and dry, free of dust or grease.
• Trace the outline of your patch with a pencil and protect it with a painter's tape

Caution: The adhesive and the materials to be bonded must not be used at temperatures below +18°C.
Adhesive exposed to low temperatures must be thoroughly mixed and tempered to a temperature of 18 - 30°C minimum 72 hours before use.

BONDING OF MATERIALS

1. Apply a thin, even film of glue to the two materials to be joined.
2. Wait at least 10 minutes. The glue on both sides should become matt and not stick to your fingers.
3. Get ready to glue! The glue sets immediately, so make sure you are facing the right way.
4. Apply strong pressure between the Float Tube and the base to be bonded.
5. Use a teaspoon to press down on the ends of the pad.
6. Remove the tape.

Do not store for more than 6 months at room temperature in the unopened original packaging at a temperature of 15°C to 25°C. Always close the package tightly during use to avoid thickening of the adhesive due to evaporation of solvents.