ITC+ cooling unit with water cooled SP

AN INTELLIGENT COMBINATION

The ITC+ (eutectic plate & ITC thermostat) water-cooled chiller is particularly suitable for boats without a constant power source.

It keeps food fresh without the need for a continuous power supply, thanks to the eutectic liquid that can store the cold, saving battery power.

The intelligent system detects when a surplus of energy is available to"recharge" the eutectic plate with cold. Conversely, when excess power is no longer available, the system reduces its consumption.

Thanks to the intelligent ITC thermostat and temperature sensor, energy consumption can be optimized by controlling compressor operation and adjusting the cooling power actually required.

INNOVATIVE TECHNOLOGY

The ITC+ 3251 chiller with SP technology is cooled by seawater. It's the water-cooled condenser that removes the heat from the mechanism. There's no need for pumps and fans to remove heat.
Battery consumption is therefore reduced, making the chiller quieter.

The SP system takes advantage of the boat's natural movements to pump seawater and cool the refrigerant. A special fitting in the sink drain allows the water to circulate freely, using every movement of the water to pump and exchange heat efficiently.

What's more, because this fitting is positioned away from the center of gravity, even a small movement of the boat is enough to activate pumping, resulting in continuous hot water withdrawal and cold water suction while preventing dirt build-up.

AN INFINITE REFRIGERATION CYCLE

The ITC+ 3251 chiller is specifically designed to be powered by seawater. Here's how the system works

1. The system draws in seawater through an intake located under the boat's hull
2. The usually gaseous refrigerant is compressed in the compressor. This increases its pressure and temperature
3. The refrigerant circulates through a condenser, releasing its heat into the seawater. This condenses the refrigerant into a high-pressure liquid
4. The refrigerant passes through an expansion valve where its pressure drops, cooling its temperature. It then becomes a mixture of liquid and very cold gas at low pressure
5. This mixture circulates inside the eutectic plates. The evaporator absorbs the heat from the eutectic mixture, freezing it and allowing the refrigerant to evaporate.
   This heat transfer process reduces the temperature inside the compartment, while the eutectic solution stores the cold.
6. The refrigerant, in its gaseous state, returns to the compressor to repeat the cycle indefinitely.

These steps are perpetually repeated to cool your food. The seawater used for condensation is generally discharged outside the boat after absorbing the heat from the refrigerant.

MAIN FEATURES :

• SP technology
• BD35 F compressor
• Water cooling
• Quick and easy installation
• Model U100X035A17361AA
• Evaporator with cold accumulator
• Intelligent thermostat temperature control

BOX CONTENTS :

• 1 - Danfoss BD35 F compressor
• 1 - ASU eutectic plate
• 1 - Compressor connection hose 1.5 m
• 1 - Evaporator connection hose 3 m
• 1 - SP shell pass capacitor
• 1 - SP through-hull anode
• 1 - ITC thermostat
• 1 - Fixing bracket
• 1 - Screw kit
• 1 - PDF documentation