Apparent Wind Monitor

APPARENT WIND MONITOR INTERFACE

The Wind Monitor is a robust interface that isolates your boat's mast line from the rest of your installation.

It provides the following functions

• isolation of the main system from the mast system in the event of a short-circuit or overvoltage

• manual or automatic switchover to a second or third anemovane sensor

• switch to compass mode if the system has only one wind vane sensor on board, without losing pilot control

• wind denoising: reduces your pilot's power consumption by 50% , optimizing performance. Piloting with a real active wind denoised, you'll get greater pilot precision with reduced rudder inputs.

Warning :

The "wind denoising" function is only available when using a reactive wind sensor.

The HR anemovane sensor from NKE features a redesigned reel and blade. The reel is also lighter.

The sensor is equipped with a high-resolution digital decoder, providing sensitivity close to a tenth of a degree. Its wind denoising algorithm has been developed for the Processor HR.

KEY POINTS

• Tightness: IP54
• NMEA 0183 output
• Power supply: 9 to 34DC
• Power consumption
• Dimensions: 120 x 90 x 51 mm

WIND MONITOR CONTENTS

• 1 - Apparent Wind Monitor interface
• 1 - TOPLINE bus power cable (4 conductors + ground wire)
• 1 - PDF documentation