Bar angle indicator Ø 85mm 12/24V

These new indicators automatically detect whether they are being used as master or slave.
The same dial performs both master and slave functions.
The instrument connected directly to the sensor acquires the signal, converts it to CAN bus and transmits it to the other instrument, which will operate in repeater mode.
Up to 3 repeaters can be added.

Automatic calibration function:

• By pressing the 2 buttons on the back of the indicator while moving the rudder from port to starboard, the instrument automatically calibrates itself.
• The data is stored in the instrument's permanent memory.

Rudder angle indicator 12/24V
Sensor signal: 0-1 kΩ, 4-20 mA, Can bus
Ø drilling: 85mm,
Ø HT: 91mm